Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Chevrolet Epica LSFACTORY OEM SERVICE PROCEDURE
Wheel Alignment Specifications
| Wheel Alignment Angle | Suspension | |
|---|---|---|
| Front | Rear | |
| Camber | ||
|
-1.5 to +0.5 degrees | -2.5 to -0.5 degrees |
|
-1.3 to +0.7 degrees | -2.5 to -0.5 degrees |
| Caster | ||
|
2-4 degrees | - |
|
1.9-3.9 degrees | - |
| Toe-in | ||
|
-0.066 to +0.266 degrees | -0.016 to +0.316 degrees |
|
-0.066 to +0.266 degrees | -0.066 to +0.266 degrees |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.