2004 Chevrolet ClassicFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: View of Catalytic Converter Seal
    GM25299Courtesy of GENERAL MOTORS CORP.
  1. Install the 3-way catalytic converter seal.
  2. Fig 2: View of Intermediate Pipe
    GM182079Courtesy of GENERAL MOTORS CORP.
  3. Install the intermediate pipe to the hanger.
  4. Fig 3: View of Intermediate Pipe and 3-Wat Catalytic Converter
    GM25271Courtesy of GENERAL MOTORS CORP.
  5. Install the intermediate pipe to the 3-way catalytic converter bolts.

    Tighten:Β  Tighten the bolts to 34 N.m (25 lb ft).

  6. Fig 4: Identifying Cutline On Intermediate Pipe
    GM25822Courtesy of GENERAL MOTORS CORP.
  7. Clamp the muffler (2) to the intermediate pipe (1).

    Tighten:Β  Tighten the clamp to 50 N.m (37 lb ft).

  8. Lower the vehicle.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.