2004 Chevrolet ClassicFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Switches

SWITCHES LOCATION

Component Location
Brake Fluid Level Switch On brake master cylinder reservoir. See Figure .
Coolant Level Switch Right front of engine compartment. See Figure .
Door Ajar Switch Connector (Driver) Rear of left front door. See Figure .
Door Ajar Switch Connector (Front Passenger) Rear of right front door. See Figure .
Door Ajar Switch Connector (Left Rear & Right Rear) Rear of door. See Figure .
Engine Oil Level Switch Rear of engine.
Park Brake Switch On park brake assembly. See Figure .
Park/Neutral Position (PNP) Switch On side of transaxle. See Figure .
Seat Belt Switch Connector Under left front seat. See Figure .
Stop Lamp Switch On brake pedal support. See Figure .
TCC/Brake Switch On brake pedal support. See Figure .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.