Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Chevrolet ClassicFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Connectors
CONNECTORS LOCATION
| Component | Location |
|---|---|
| C101 (Black, 10 Pin) | On left side of engine compartment, in fuse block. See Figure . |
| C102 (20 Pin) | Left side of engine. See Figure . |
| C103 | Front of transaxle. See Figure . |
| C104 | Left front of engine. See Figure . |
| C130 (Black, 8 Pin) | On top front of engine. |
| C200 (Black, 18 Pin) | Below left side of dash, near steering column. See Figure . |
| C206 (Black, 4 Pin) | Below left side of dash, near steering column. See Figure . |
| C207 (Black, 4 Pin) | In steering wheel. |
| C274 (Yellow, 2 Pin) | Left side of dash, near fuse block. See Figure . |
| C275 (Yellow, 2 Pin) | Right side of dash, near fuse block. |
| C300 (White, 10 Pin) | Below left side of dash, near steering column. See Figure . |
| C301 (Black, 3 Pin) | In left side of headliner. See Figure . |
| C400 (Clear, 8 Pin) | In left rear of passenger compartment. See Figure . |
| C413 (Natural, 16 Pin) | Under right rear of vehicle. See Figure . |
| C500 (Gray, 18 Pin) | Behind left front kick panel. See Figure . |
| C501 (Black, 18 Pin) | Behind left front kick panel. See Figure . |
| C600 (Black, 18 Pin) | Behind right kick panel. See Figure . |
| C700 (Black, 7 Pin) | Left "B" pillar. See Figure . |
| C800 (Black, 7 Pin) | Right "B" pillar. See Figure . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
