Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Chevrolet ClassicFACTORY OEM SERVICE PROCEDURE
Installation Procedure
- Install a stationary window into the opening. Refer to Urethane Adhesive Installation of Stationary Windows .
- Install the inside rearview mirror. Refer to Rearview Mirror Replacement .
- Install the air inlet grille. Refer to Air Inlet Grille Panel Replacement in Body Front End.
- Close the hood.
- Install the antenna, if equipped.
- Install the windshield wiper arms. Refer to Wiper Arm Replacement in Wipers/Washer Systems.
- Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.