2004 Chevrolet Astro Van Cargo, AWDFACTORY OEM SERVICE PROCEDURE

Removal Procedure

  1. Remove the engine cover. Refer to Engine Cover Replacement in Interior Trim.
    Fig 1: View Of Throttle Position (TP) Sensor Harness Connector
    GM12885Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the throttle position (TP) sensor harness connector.
  3. Remove the mounting bolts from the TP sensor.
    Fig 2: Identifying Throttle Position (TP) Sensor Mounting Bolts
    GM10935Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.