Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Chevrolet Astro Van Cargo, AWDFACTORY OEM SERVICE PROCEDURE
Disassembly Procedure
- Remove the engine cover. Refer to Engine Cover Replacement
in Interior Trim.NOTE: The ignition system distributor driven gear and rotor may be installed in multiple positions. In order to avoid mistakes, mark the distributor on the following components in order to ensure the same mounting position upon reassembly:
- The distributor driven gear
- The distributor shaft
- The rotor holes
Installing the driven gear 180 degrees out of alignment, or locating the rotor in the wrong holes, will cause a no-start condition. Premature engine wear or damage may result. - Align white paint mark on the bottom stem of the distributor, and the pre-drilled indent hole in the bottom of the gear (2).
- With the gear in this position, the rotor segment should be positioned as shown for a V6 engine (1). If not, replace the distributor.
- Remove the 2 screws from the rotor.
- Remove the rotor.
- Note the locating holes that the rotor was removed from:
- The rotor screw holes (1)
- The rotor locator pin holes (2)
- Line up the square-cut hole in the vane wheel with the CMP sensor.
- Remove the 2 screws that hold the camshaft position (CMP) sensor.
- Discard the screws.
- Remove the CMP sensor.
- Note the dimple located below the roll pin hole on one side of the gear. The dimple will be used to properly orient the gear onto the shaft during reassembly.
- Support the distributor drive gear in a V-block or similar fixture.CAUTION: Refer to SAFETY GLASSES CAUTION in Cautions and Notices.
- Drive out the roll pin with a suitable punch.
- Remove the driven gear from the distributor shaft.
- Remove the round washer.
- Remove the tang washer.
- Remove the shim washer (1).
- Remove the old oil seal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
