2003 Chevrolet Venture LT, FWDFACTORY OEM SERVICE PROCEDURE

Component Locations

NOTE: For component locations, refer to COMPONENT LOCATIONSΒ  table or illustrations. See Fig 1 -Fig 8 .
COMPONENT LOCATIONS

Component Location
A/C Refrigerant Pressure Sensor Below Accumulator, Below Air Cleaner Assembly
Body Control Module Below Right Side Of Instrument Panel, Right Of Glove Box
Camshaft Position Sensor Above A/C Compressor Clutch
Crankshaft Position Sensor (7x) Lower Rear Of Engine
Crankshaft Position Sensor (24x) Behind Harmonic Balancer
Cruise Control Module Near Left Strut Tower
Data Link Connector Below Steering Column, Bottom Of Knee Bolster
EGR Valve Upper Left Side Of Engine
Engine Coolant Temperature Sensor Top Left Side Of Engine
Engine Oil Level Indicator Switch Center Of Engine Oil Pan
Engine Oil Pressure Indicator Switch Above Starter
EVAP Canister Purge Solenoid Above Starter
EVAP Canister Vent Solenoid Forward Of Fuel Tank
Fuel Injectors Top Of Engine At Each Cylinder Intake Port
Fuel Pump Relay In Underhood Junction Block
Fuel Tank Pressure Sensor Top Of Fuel Tank
Heated Oxygen Sensor No. 1 Rear Of Engine, In Exhaust Manifold
Heated Oxygen Sensor No. 2 Behind Catalytic Converter
Idle Air Control Valve Top Of Engine, Front Of Throttle Body
Ignition Control Module Top Center Rear Of Engine
Intake Air Temperature Sensor On Air Intake Duct, Near Throttle Body
Knock Sensor Front Of Engine, Above Starter
Manifold Absolute Pressure Sensor Right Top Of Engine
Mass Airflow Sensor In Air Cleaner Duct
Powertrain Control Module In Air Cleaner Assembly
Secondary AIR Injection Pump Mounted In Lower Portion Of Left Front Fender
Secondary AIR Injection Solenoid Right Side Of Engine Compartment, Behind Horn
Throttle Position Sensor On Throttle Assembly
Underhood Fuse Block In Right Front Wheelwell, Above Battery
Vehicle Speed Sensor Mounted To Right Side Of Transaxle
Fig 1: Locating Camshaft Position Sensor
G00101522Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.