Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit Description
The Ignition Control (IC) module has independent power and ground circuits. The circuits between the IC module and the PCM consist of the IC timing signal, IC timing control, low resolution engine speed signal and a low reference signal.
The IC module sends 3X signals to the PCM. The IC module controls the timing advance during engine cranking. The timing advance changes to PCM control after the PCM receives the second 3X signal and after the PCM applies 5 volts to the IC timing signal circuit.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.