Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Chevrolet Venture Base, Van Cargo ExtendedFACTORY OEM SERVICE PROCEDURE
Instrument Panel DTCS
INSTRUMENT PANEL DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description |
|---|---|
| DTC B0160 | Temp Sensor Circuit Low |
| DTC B0162 | Temp Sensor Circuit Open |
| DTC B0931 | Compass Sensor Circuit Malfunction |
| DTC B1440 | Power Mode Master Input Circuits Mismatch |
| DTC B2823 or B3574 | Driver Information Center (DIC) Switch Circuit |
| DTC P0462 | Fuel Level Sensor Circuit Low Voltage |
| DTC P0463 | Fuel Tank Pressure Sensor Circuit High Voltage |
| DTC P1189 | Engine Oil Pressure (EOP) Switch Circuit |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
