2003 Chevrolet Venture Base, Van Cargo ExtendedFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

Application Ft. Lbs. (mm)
Battery Hold Down Bolt 13 (18)
Battery Negative Terminal Bolt 11-13 (15-17)
Battery Positive Cable Junction Block Lead Nut 11 (15)
Battery Positive Terminal Bolt 11-13 (15-17)
Generator Pulley Shaft Nut 74 (100)
Transaxle Stud Nut 18 (25)
Generator Bolt (Long & Short) 37 (50)
Generator Output BAT Terminal Nut 15 (20)
Generator Pivot Bolt 37 (50)
Generator Rear Brace Nut 18 (25)
INCH Lbs.Β 
Battery Negative Cable Bolt-To-Frame Rail 71 (8)
Battery Tray Bolts 44 (5)
Underhood Accessory Wiring Junction Block Nut 18 (2)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.