SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 785 (INTERIOR TRIM)DASHBOARD GARNISH REMOVAL/INSTALLATIONDRIVER'S SIDE
2003 Chevrolet TrailBlazer 4.2 S, 4WD

Driver's Side

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Driver's Side
WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the following parts:
    1. A-pillar trim (See A-PILLAR TRIM REMOVAL/INSTALLATION .)
    2. Front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
    3. Front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION .)
    4. Hood release lever (See HOOD LATCH AND RELEASE LEVER REMOVAL/INSTALLATION .)
    5. Lower panel (See LOWER PANEL REMOVAL/INSTALLATION .)
    6. Decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION .)
    7. Dashboard center panel (See DASHBOARD CENTER PANEL REMOVAL/INSTALLATION .)
    8. Meter hood (See METER HOOD REMOVAL/INSTALLATION .)
    9. Instrument cluster (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .)
  3. Remove the screws.
  4. Pull the dashboard garnish outward, and detach clips A.
  5. Remove the dashboard garnish.
  6. Install in the reverse order of removal.
    Fig 1: Removing/Installing Dashboard Garnish - Driver's Side
    G02566805Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.