2003 Chevrolet SSR LSFACTORY OEM SERVICE PROCEDURE

Installation Procedure

  1. Install the negative battery cable to vehicle.
  2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the nut to retain the negative battery cable to the right side frame rail.

    Tighten:Β  Tighten nut to 25 N.m (18 lb ft).

  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect ProcedureΒ .
  5. Install the rear battery cover and nuts.

    Tighten:Β  Tighten nuts to 10 N.m (89 lb in).

  6. Lower the vehicle.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.