Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Chevrolet SSR BaseFACTORY OEM SERVICE PROCEDURE
Power Seat DTCS
SEAT DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description |
|---|---|
| DTC B1735, B1740, B1745, B1750, B1755, B1760, B1815, or B1820 | Switch Signal Circuit To The Seat Module Is Active For More Than 60 Seconds |
| DTC B1825, B1850, B1860, B2355, B2365, or B2375 | Position Sensor Signal Circuit Voltage |
| DTC B2425 or B2430 | Low Side Drive Control Circuits, Or Heater Element Voltage Supply Circuits |
| DTC B2435 or B2440 | Heated Seat Sensor Signal Circuit Voltage, Or Heated Seat Sensor Signal Input Circuit |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.