Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Chevrolet SSR BaseFACTORY OEM SERVICE PROCEDURE
Engine Cooling System Torque Specifications
ENGINE COOLING SYSTEM TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Coolant Heater | 37 (50) |
| Engine Block Coolant Drain Plug | 44 (60) |
| Fan Clutch Bolt | 17 (23) |
| Fan Clutch Nut | 41 (56) |
| Radiator Bolt | 18 (25) |
| Thermostat Housing Bolt | 11 (15) |
| Water Pump Bolt (First Pass) | 11 (15) |
| Water Pump Bolt (Final Pass) | 22 (30) |
| INCH Lbs. (N.m) | |
| Air Cleaner Outlet Duct Clamp Screw | 62 (7) |
| Auxiliary Water Pump Bracket Nut | 80 (9) |
| Coolant Air Bleed Pipe Stud/Bolt | 106 (12) |
| Coolant Heater Cord Bolt | 71 (8) |
| Fan Shroud Bolt | 80 (9) |
| Surge Tank Bolt/Nut | 80 (9) |
| Transmission Control Module (TCM) Cover Bolt | 80 (9) |
| Transmission Control Module (TCM) Electrical Connector Bolt | 71 (8) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.