2003 Chevrolet SSR BaseFACTORY OEM SERVICE PROCEDURE

HVAC System Torque Specifications

HVAC SYSTEM TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
A/C Compressor
Bracket Bolt 37 (50)
Mounting Bolt 37 (50)
Compressor Hose
Assembly-To-Compressor Retaining Nut 15 (20)
To-Condenser Fitting Bolt 12 (16)
Liquid Line
To-Compressor Hose Nut 12 (16)
To-Condenser Fitting Bolt 12 (16)
TXV Block Fitting Nut 15 (20)
In. Lbs. (N.mΒ  )
A/C Refrigerant Pressure Sensor 44 (5)
Actuator Retaining Bolts 17 (1.9)
Blower Motor
Bracket Bolt 89 (10)
Nut 89 (10)
Resistor Retaining Screws 17 (1.9)
Retaining Screws 14 (1.6)
Heater Core
Clamp Screw 17 (1.9)
Pipe Clamp Screw 14 (1.6)
HVAC
Control Module Retaining Bolts 14 (1.6)
Module Case Half Screws 17 (1.9)
Module Retaining Bolts/Nut 70 (8)
Mode Actuator 17 (1.9)
Recirculation Actuator 17 (1.9)
TXV-To-Evaporator Core Mounting Bolts 62 (7)
Valve Core 97 (11)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.