Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Chevrolet SSR BaseFACTORY OEM SERVICE PROCEDURE
Special Tools
Special Tools
| Illustration | Tool Number/Description |
|---|---|
| J 23738-A Vacuum Pump |
|
| J 26792 Spark Tester |
|
| J 33431-B Signal Generator and Instrument Panel Tester |
|
| J 34142-B Test Lamp |
|
| J 34730-E Fuel Pressure Gage Kit |
|
| J 34730-1A Fuel Pressure Gage |
|
| J 34730-405 Injector Test Lamp |
|
| J 35616-A Connector Test Adapter Kit |
|
| J 37027-1A I IAC Motor Driver |
|
You may also use an IAC Motor Driver from one of the approved manufacturers listed below:
|
|
| J 37287 Inlet and Return Fuel Line Shut-Off Adapters |
|
| J 38500-A Fuel Injector Cleaner |
|
| J 38522 Variable Signal Generator |
|
| J 39021 Fuel Injector Coil and Balance Tester |
|
| J 39021-380 Fuel Injector Test Harness |
|
| J 39194-B Oxygen Sensor Wrench |
|
| J 39200 Digital Multimeter |
|
| J 41413 EVAP Pressure/Purge Diagnostic Station |
|
| J 41415-40 Fuel Fill Cap Adaptor |
|
| J 41416 Ultrasonic Leak Detector |
|
| J 41769 Fuel Line Quick Disconnect Tool |
|
| J 42598 Vehicle Data Recorder |
|
| J 42873-1 3/8 Fuel Line Shut-Off Adapter |
|
| J 42873-2 5/16 Fuel Line Shut-Off Adapter |
|
| J 42964-1 Fuel Line Shut-Off Adapter |
|
| J 42964-2 Fuel Line Shut-Off Adapter |
|
| J 43013 Fuel Injector Assembly Removal Tool |
|
| J 44175 Fuel Composition Tester |
|
| J 44402 Fuel Sending Unit Wrench |
|
| J 44602 Injector Test Adapter |
|
| J 44603 Injector Test Lamp |
|
| Tech 2 Kit 7000081 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
