2003 Chevrolet SSR BaseFACTORY OEM SERVICE PROCEDURE

Powertrain Control Module (PCM) Connector End Views

Powertrain Control Module C1

GM73173Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • 12191110
  • 80-Way F Micro-Pack 100 Series, Sealed (BU)
Pin Wire Color Circuit No. Function
1 BK 450 Ground
2 L-GN 1867 Crankshaft Position Sensor 12-Volt Reference
3 PK/BK 1746 Fuel Injector Control 3
4 L-GN/BK 1745 Fuel Injector Control 2
5-6 - - Not Used
7 GY 705 5-Volt Reference
8-10 - - Not Used
11 L-BU 1876 Knock Sensor Signal 2
12 D-BU/WH 1869 Crankshaft Position Sensor Signal
13 OG/BK 463 Requested Torque Signal
14 D-BU/WH 774 UART Serial Data Tertiary
15 OG/BK 1061 UART Serial Data Secondary
16 - - Not Used
17 D-BU 1225 Transmission Fluid Pressure Switch Signal Bit 2
18 RD 1226 Transmission Fluid Pressure Switch Signal Bit 3
19 PK 439 Run/Crank Ignition 1 Voltage
20 OG 440 Battery Positive Voltage
21 YE/BK 1868 Low Reference
22 - - Not Used
23 BK 2759 Fuel Tank Pressure Sensor Low Reference
24 BK 450 Ground
25 TN 1671 Heated Oxygen Sensor Low Signal Bank 2 Sensor 2
26 TN 1667 Heated Oxygen Sensor Low Signal Bank 2 Sensor 1
27 BK 450 Ground
28 TN/WH 1669 Heated Oxygen Sensor Low Signal Bank 1 Sensor 2
29 TN 1664 Heated Oxygen Sensor Low Signal Bank 1 Sensor 1
30-31 - - Not Used
32 BK/WH 771 Transmission Position Switch Bit 1 Signal
33 PU 420 Torque Converter Clutch Brake Switch Signal
34 WH 776 Transmission Position Switch Parity Bit Signal
35 - - Not Used
36 BK 1744 Fuel Injector Control 1
37 YE/BK 846 Fuel Injector Control 6
38 - - Not Used
39 YE/BK 625 Starter Enable Relay Control
40 BK 450 Ground
41 - - Not Used
42 D-GN 335 Low Speed Cooling Fan Relay Control
43 RD/BK 877 Fuel Injector Control 7
44 L-BU/BK 844 Fuel Injector Control 4
45 GY 2700 A/C Pressure Sensor 5-Volt Reference
46 GY 2709 Fuel Tank Pressure Sensor 5-Volt Reference
47 - - Not Used
48 GY 2704 Manifold Absolute Pressure Sensor 5-Volt Reference
49-50 - - Not Used
51 D-BU 496 Knock Sensor Signal 1
52 - - Not Used
53 BK 2762 Transmission Fluid Temperature Sensor Low Reference
54 OG/BK 469 Manifold Absolute Pressure Sensor Low Reference
55-56 - - Not Used
57 OG 440 Battery Positive Voltage
58 D-GN 1049 ECM/PCM/VCM Class 2 Serial Data
59 YE 710 Class 2 Serial Data Secondary
60 - - Not Used
61 PK/BK 632 Camshaft Position Sensor Low Reference
62 - - Not Used
63 BK 407 Sensor Low Reference
64 BK 450 Ground
65 PU 1670 Heated Oxygen Sensor High Signal Bank 2 Sensor 2
66 PU 1666 Heated Oxygen Sensor High Signal Bank 2 Sensor 1
67 BK 450 Ground
68 PU/WH 1668 Heated Oxygen Sensor High Signal Bank 1 Sensor 2
69 PU/WH 1665 Heated Oxygen Sensor High Signal Bank 1 Sensor 1
70-71 - - Not Used
72 YE 772 Transmission Position Switch Bit 2 Signal
73 BN/WH 633 Camshaft Position Sensor Signal
74 YE 410 Engine Coolant Temperature Sensor Signal
75 PK 1020 Off/Run/Crank Voltage
76 BK/WH 845 Fuel Injector Control 5
77 D-BU/WH 878 Fuel Injector Control 8
78 - - Not Used
79 WH 687 3-2 Shift Solenoid Valve Control
80 GY 720 Sensor Low Reference
Powertrain Control Module C2

GM73173Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • 12191110
  • 80-Way F Micro-Pack 100 Series, Sealed (BU)
Pin Wire Color Circuit No. Function
1 BK 450 Ground
2 BN 418 Torque Converter Clutch PWM Solenoid Control
3-4 - - Not Used
5 TN/BK 464 Delivered Torque Signal
6 RD/BK 1228 Transmission Force Motor Supply Voltage 1
7 - - Not Used
8 L-BU/WH 1229 Transmission Force Motor Low Reference 1
9 D-GN/WH 465 Fuel Pump Primary Relay Control
10 WH 121 Engine Speed Signal
11-13 - - Not Used
14 RD/BK 380 A/C Refrigerant Pressure Sensor Signal
15 RD 225 Generator Turn On Signal
16-17 GY/BK 1694 Four Wheel Drive Low Signal
18 D-GN 1433 Clutch Start Switch Signal
19 - - Not Used
20 L-GN/BK 822 Vehicle Speed Sensor Low Reference
21 PU/WH 821 Vehicle Speed Sensor Signal
22-24 - - Not Used
25 TN 472 Intake Air Temperature Sensor Signal
26 PU 2121 Ignition Control 1
27 RD 2127 Ignition Control 7
28 L-BU/WH 2126 Ignition Control 6
29 D-GN/WH 2124 Ignition Control 4
30 - - Not Used
31 YE 492 Mass Air Flow Sensor Signal
32 L-GN 432 Manifold Absolute Pressure Sensor Signal
33 D-BU 473 High Speed Cooling Fan Relay Control
34 D-GN/WH 428 EVAP Canister Purge Solenoid Control
35-38 - - Not Used
39 RD 631 Camshaft Sensor 12-Volt Reference
40 BK 450 Ground
41 - - Not Used
42 TN/BK 422 Torque Converter Clutch Solenoid Control
43 D-GN/WH 459 A/C Compressor Clutch Relay Control
44 - - Not Used
45 WH 1310 EVAP Canister Vent Solenoid Control
46 BN/WH 419 Check Engine Indicator Control
47 YE/BK 1223 2 Shift Solenoid Valve Control
48 D-GN 1222 1 Shift Solenoid Valve Control
49 YE/BK 1827 Vehicle Speed Signal
50 D-GN/WH 817 Vehicle Speed Signal
51 YE/BK 1227 Transmission Temperature Sensor Signal
52 BN 2391 HO2S Heater Low Control Bank 1 Sensor 2
53 RD/WH 3223 Heated Oxygen Sensor Heater Low Control Bank 2 Sensor 2
54 PU/WH 1589 Primary Fuel Level Sensor Signal
55-56 - - Not Used
57 BK 2760 Intake Air Temperature Sensor Low Reference
58 TN/WH 332 Oil Pressure Sensor Signal
59 PU 806 Crank Voltage
60 BN 2129 Ignition Control Low Reference Bank 1
61 BN/WH 2130 Ignition Control Low Reference Bank 2
62 GY 773 Transmission Position Switch Bit 3 Signal
63 PK 1224 Transmission Fluid Pressure Switch Signal Bit 1
64 D-GN 890 Fuel Tank Pressure Sensor Signal
65 - - Not Used
66 PU 2128 Ignition Control 8
67 RD/WH 2122 Ignition Control 2
68 D-GN 2125 Ignition Control 5
69 L-BU 2123 Ignition Control 3
70-71 - - Not Used
72 BK/WH 3113 Heated Oxygen Sensor Heater Low Control Bank 1 Sensor 1
73 - - Not Used
74 L-GN 3212 Heated Oxygen Sensor Heater Low Control Bank 2 Sensor 1
75 GY 23 Generator Field Duty Cycle Signal
76-79 - - Not Used
80 BK 2751 Signal Ground
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.