2003 Chevrolet SSR BaseFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Install the strap and bolt to engine block.

    Tighten:Β  Tighten bolt to 50 N.m (37 lb ft).

  2. Lower the vehicle.
  3. Install the nut to retain strap to frame.

    Tighten:Β  Tighten nut to 25 N.m (18 lb ft).

  4. Close the hood.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.