2003 Chevrolet SSR BaseFACTORY OEM SERVICE PROCEDURE

Removal Procedure

    Fig 1: Brake Rotor Removed From Hub
    GM748559Courtesy of GENERAL MOTORS CORP.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  3. Remove the brake rotor. Refer to REMOVAL (FRONT) in Disc Brake.
  4. Fig 2: Identifying Wheel Speed Sensor Wiring Harness
    GM886518Courtesy of GENERAL MOTORS CORP.
  5. Remove wheel speed sensor wiring harness the retainers.
  6. Fig 3: Locating Connector
    GM886517Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the wheel speed sensor electrical connector.
  8. Fig 4: Locating Wheel Speed Sensor Mounting Screw
    GM777335Courtesy of GENERAL MOTORS CORP.
  9. Remove the sensor mounting screw.
  10. Fig 5: Removing/Installing Speed Sensor
    GM748580Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.