Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Chevrolet SSR BaseFACTORY OEM SERVICE PROCEDURE
Removal Procedure
- Open the hood.
- Cover and protect the following parts from broken glass:
- The upper dash pad
- The defroster outlets and A/C outlets
- The seats and carpeting
- Disconnect the antenna cable. Refer to Antenna Cable Replacement in Entertainment.
- Remove the windshield wiper arms. Refer to Wiper Arm Replacement in Wipers/Washer Systems.
- Remove the cowl air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
- Remove the windshield frame appliques. Refer to Applique Replacement - Windshield Frame in Exterior Trim.
- Remove the rearview mirror. Refer to Rearview Mirror Replacement .
IMPORTANT:
Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
CAUTION:
If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.