2003 Chevrolet SSR BaseFACTORY OEM SERVICE PROCEDURE

Theft Deterrent DTCS

THEFT DETERRENT DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description
DTC B2947 Short To Ground On The Passlock Sensor 12-Volt Reference Circuit
DTC B2948 Sensed Battery Voltage
DTC B2957 BCM Signal Input Low
DTC B2958 BCM Signal Input High
DTC B2960 Valid But Different Code Value Than Previously Learned Form The Passlock™ Sensor
DTC B3031 BCM is In Learn Mode But Does Not See A Valid Passlock™ Sensor Code
DTC B3033 BCM Is Reading A Tamper Code From The Passlock™ Sensor
DTC P1626 PCM Has Not Established Communications With BCM
DTC P1630 Enable Learning Flag Is Set
DTC P1631 PCM Did Not Receive A Valid Password
DTC P1632 Undecided Password Was Sent From The BCM
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.