Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Service Programming Methods
The 4 methods of programming a control module and the proper tools for each method are as follows:
- Remote Programming:
- The Tech 2 or other scan tool, Techline Terminal or a personal computer equipped with General Motors Corporation authorized programming software-The Tech 2 or other scan tool is used as an interface between the vehicle and the Techline Terminal or a personal computer.
- The control module is installed in the vehicle
- Pass Thru Programming:
- The Tech 2 or other scan tool, Techline Terminal or a personal computer equipped with General Motors Corporation authorized programming software-The Tech 2 or other scan tool is used as an interface between the vehicle and the Techline Terminal or a personal computer.
- The control module is installed in the vehicle.
- Off-Board Remote Programming, vehicle NOT available:
- The Tech 2 or other scan tool, off-board programming adapter (OBPA), Techline Terminal or a personal computer equipped with General Motors Corporation authorized programming software-The Tech 2 or other scan tool is used as an interface between the vehicle and the Techline Terminal or a personal computer.
- The control module is NOT installed in a vehicle
- Off-Board Pass Thru Programming
- The Tech 2 or other scan tool, off-board programming adapter (OBPA), Techline Terminal or a personal computer equipped with General Motors Corporation authorized programming software-The Tech 2 or other scan tool is used as an interface between the vehicle and the Techline Terminal or a personal computer.
- The control module is NOT installed in a vehicle
All 4 methods may not be available for every vehicle.
For information on programming a control module using one of the methods listed above, refer to Service Programming System (SPS) (Remote Procedure) or Service Programming System (SPS) (Pass-Thru Procedure) or Service Programming System (SPS) (Off Board Remote Procedure) or Service Programming System (SPS) (Off Board Pass-Thru Procedure) .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.