Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Body Control Module (BCM) Programming/RPO Configuration: Introduction
The procedure below is designed to set-up the body control module (BCM) correctly after BCM related service. The Service Programming System (SPS) uses the vehicle identification number (VIN) to determine the regular production option (RPO) configuration that the vehicle had when it was built. The SPS programs the BCM with the RPO configuration. After a new BCM is programmed, the powertrain control module (PCM) must learn the new BCM's Passlock fuel enable password. Before you start, read these procedures carefully and completely.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.