Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Service Programming System (SPS) (Off Board Remote Procedure)
Tools Required
J 41207-C Off-Board Programming Adapter Kit. See Special Tools .
The J 41207-C is required when a module must be programmed without having the vehicle present. See Special Tools . The adapter allows the module to be turned ON and communicate with the scan tool.
For additional SPS information, refer to Service Programming System (SPS) Description .
Performing the Off Board Remote Procedure
- Obtain the vehicle identification number (VIN) of the vehicle for which the module is being programmed.
- Launch the TIS application at the terminal.
- Select the Service Programming System.
- Highlight the following information on the Select Diagnostic Tool and Programming Process screen:
- Select Diagnostic Tool-Select Tech 2
- Select Programming Process-Identify whether an existing module is being reprogrammed or replaced with a new one.
- Select ECU location-select Off-Board Programming Adapter.
- Select Next.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.