2003 Chevrolet Chevy Express H2500FACTORY OEM SERVICE PROCEDURE

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
  2. Unsnap the jounce bumper from the mounting cup (4WD 15 Series).
    Fig 1: Unsnapping Jounce Bumper From Mounting Cup
    G01455461Courtesy of GENERAL MOTORS CORP.
  3. Remove the nut from the jounce bumper stud (All 25/35 Series and RWD 15 Series with coil spring).
  4. Remove the jounce bumper.
    Fig 2: Removing Nut From Jounce Bumper Stud
    G01455462Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.