2002 Chevrolet Venture PlusFACTORY OEM SERVICE PROCEDURE

Installation Procedure

WARNING: This page is about a different car, the 2002 Cadillac Seville. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the RIM (1) to the electrical component mounting panel.
  2. Push the RIM (1) into the opening on the electrical component mounting panel, until an audible click is heard, indicating the Rim (1) is secured to the electrical component mounting panel.
  3. Connect the electrical connections to the RIM (1).
    Fig 1: Connecting RIM Electrical Connectors
    G01797132Courtesy of GENERAL MOTORS CORP.
  4. Install the electrical component mounting panel (1) to the vehicle body.
    NOTE: Refer to FASTENER NOTICE .
  5. Install the electrical component mounting panel nuts (2).

    Tighten 

    Tighten the nuts (2) to 9 N.m (80 lb in).

  6. Install the rear storage compartment trim. Refer to COMPARTMENT TRIM PANEL REPLACEMENT - REAR .
  7. Restore the drivers personalization settings. Refer to DRIVER PERSONALIZATION .
    Fig 2: Installing Electrical Component Mounting Panel & Nuts
    G01797133Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.