2002 Chevrolet Venture PlusFACTORY OEM SERVICE PROCEDURE

Removal & Installation

WARNING: This page is about a different car, the 2001 Cadillac Seville. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Before replacing Dash Integration Module (DIM), record personalization settings, to transfer into new module. See DASH INTEGRATION MODULE  under PROGRAMMING.

Disconnect negative battery cable. Remove right sound insulator from under right side of dash. Disconnect DIM harness connectors. Depress locking tab inward and slide DIM downward. Remove DIM from bracket. To install, reverse removal procedure. Program DIM. See DASH INTEGRATION MODULE  under PROGRAMMING.

Chapter Navigation
Return to Chapter: Dash Integration Module
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.