WARNING: This page is about a different car, the 2001 Cadillac Seville. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch to RUN position.

NOTE: If tire pressure monitoring programming mode cannot be entered, ensure if Dash Integration Module (DIM) is properly configured with correct Regular Production Option (RPO) codes.

Press remote transmitter lock and unlock buttons simultaneously for several seconds. Horn will chirp to indicate tire pressure monitoring programming mode has been activated.
Beginning with left front tire, install Tire Pressure Monitor Programming Tool (J-41760).

NOTE: If horn does not chirp after 15 seconds, remove, then install Tire Pressure Monitor Programming Tool (J-41760).

Horn will chirp, indicating left front tire pressure monitoring sensor is programmed.
When horn chirps, proceed to program remaining tire pressure monitoring sensors as follows: right front tire, right rear tire and left rear tire.
After left rear sensor is programmed, horn will chirp twice to indicate programming is complete.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Programming Sensor

Use the Manual With the Right Hardware

When to See a Mechanic

Rather have a pro handle this?