2002 Chevrolet Venture PlusFACTORY OEM SERVICE PROCEDURE

Code Enable Criteria

WARNING: This page is about a different car, the 2001 Cadillac Seville. However, it is still accessible from the selected car via links, so may be relevant.

The following must occur for DTC to run::

  • A control module refuses all additional inputs.
  • A control module first writes information to a cell, or address, then adds 0.25 to value, and calculates a check sum. If this checksum minus 0.25 is not equal to a cell value, a control module will store DTC.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.