2002 Chevrolet Venture PlusFACTORY OEM SERVICE PROCEDURE

Component Locations

WARNING: This page is about a different car, the 2001 Cadillac Seville. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For component locations, refer to illustrations. See Fig 1 -Fig 12 .
COMPONENT LOCATIONS

Component Location
Battery Below Passenger's Side Rear Seat
Cellular Telephone Module Behind Rear Shelf Trim, Mounted To Right Side Of Rear Shelf Carrier
Continuously Variable Road Sensing Suspension Module Behind Right Rear Seat
Cruise Control Module Rear Engine Compartment, Near Brake Booster
Dash Integration Module Behind Right Side Of Dash, Near Blower Motor
Data Link Connector Below Left Side Of Instrument Panel, Near Steering Column
Driver's Door Module In Driver's Door, Near Radio Speaker
Electronic Brake Control Module Left Front Of Engine Compartment Attached To Subframe
Instrument Panel Module Behind Center Of Dash, Part Of Climate Control Panel
Memory Seat Module Below Driver's Front Seat
Powertrain Control Module Left Front Corner Of Engine Compartment, Below Air Cleaner Housing
Rear Integration Module Behind Rear Seat Back
Rear Fuse Block Below Rear Seat
Remote Keyless Entry Module Center Of Rear Compartment, Under Package Shelf
Sensing & Diagnostic Module Below Passenger's Front Seat
Steering Column Tilt/Telescoping Module Left Of Steering Column
Theft Deterrent Module Left Side Of Instrument Panel, To Right Of Steering Column
Underhood Fuse Block On Right Side Of Engine Compartment, Near Power Steering Pump
Vehicle Communication Unit Rear Of Passenger Compartment, Behind Rear Seat Back, Mounted To Vehicle Interface Unit
Vehicle Interface Unit Rear Of Passenger Compartment, Behind Rear Seat Back, Mounted To Electronics Bay
Fig 1: Locating Rear Fuse Block
G00016936Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.