2002 Chevrolet Venture PlusFACTORY OEM SERVICE PROCEDURE

Installation Procedure

WARNING: This page is about a different car, the 2002 Cadillac Seville. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Cable Clips
    G01796045Courtesy of GENERAL MOTORS CORP.
  1. If the antenna cable is to being replaced, install the antenna cable clips (3) from the antenna cable being removed from the vehicle to the new antenna cable.
  2. Install the antenna cable to the roof beams with the clips (3).
  3. Fig 2: Installing Antenna Connection At Front Of Vehicle
    G01796046Courtesy of GENERAL MOTORS CORP.
  4. Install the antenna connection (1) at the front of the vehicle.
  5. Fig 3: Locating Antenna Cable Components
    G01796047Courtesy of GENERAL MOTORS CORP.
  6. Connect the antenna cable (2) to the antenna module, at the rear of the vehicle.
  7. Install the headliner. Refer to HEADLINER REPLACEMENT (W/O CF5) or HEADLINER REPLACEMENT (W/ CF5) .
  8. Install the sail panel. Refer to SAIL PANEL REPLACEMENT .
  9. Install the center pillar trim panel. Refer to GARNISH MOLDING REPLACEMENT - CENTER PILLAR .
  10. Install the windshield garnish molding. Refer to GARNISH MOLDING REPLACEMENT - WINDSHIELD PILLAR .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.