Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Chevrolet Venture PlusFACTORY OEM SERVICE PROCEDURE
Torque Specifications
WARNING: This page is about a different car, the 2002 Cadillac Eldorado. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Battery Cable-To-Battery Bolt | 13 (18) |
| Starter Mounting Bolts | 22 (30) |
| INCH Lbs. (N.m) | |
| Fuel Rail Bracket Retaining Nut | 35 (4.0) |
| Fuel Rail-To-Intake Manifold Bolts | 35 (4.0) |
| Intake Manifold Cover Nuts | 27 (3.0) |
| Intake Manifold-To-Cylinder Head Bolts | 89 (10) |
| Plenum Duct Clamp | 20 (2.3) |
| Positive Battery Cable-To-Solenoid Nut | 89 (10) |
| Solenoid "S" Terminal Nut | 35 (4.0) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.