2002 Chevrolet Venture PlusFACTORY OEM SERVICE PROCEDURE

Diagnostic Procedure

  1. Perform Diagnostic System Check - Engine Controls. See DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS under SELF-DIAGNOSTIC SYSTEM in SELF-DIAGNOSTICS - 6.6L SIERRA & SILVERADO article. After performing Diagnostic System Check - Engine Controls, go to next step.
  2. Are any DTCs set other than P0300, P0301-P0308? If yes, go to DIAGNOSTIC TROUBLE CODE DEFINITIONS in SELF-DIAGNOSTICS - 6.6L SIERRA & SILVERADO article. If no, go to next step.
    3. NOTE: Balance rates may not register when engine is off idle or engine coolant temperature is less than 126°F (52°C).
  3. Start and idle engine. Observe Balancing Rate Cyl. 1-8 parameters with scan tool. Are all Balancing Rate parameters within -4 mm3 and 4 mm3 ? If yes, go to step  5. If no, go to next step.
  4. Graph Fuel Pressure Regulator. See FUEL PRESSURE REGULATOR GRAPHING  under FUEL SYSTEM DIAGNOSIS - HIGH PRESSURE SIDE (6.6L). Is fuel pressure regulator graph normal? If yes, go to step  6. If no, go to step  8.
    5. NOTE: Fuel injector balance test must be performed under conditions for which concern occurred. Concern must be duplicated during test. DO NOT operate cruise control during this test. Cruise control reactivation after test may cause a brief extreme increase in engine speed.
  5. Observe engine speed or other customer concern. Perform Cylinder Power Balance Test in Special Functions. Do any cylinders indicate a different engine speed change than the others, or lessen customer concern? If yes, go to next step. If no, system is okay.
  6. Perform engine compression test. Do any cylinders have low compression? If yes, repair as necessary. See 6.6L V8 DIESEL article in ENGINES. If no, go to next step.
    7. NOTE: Failure to correctly identify cylinder positions may result in replacement of wrong fuel injector.
  7. Replace faulty fuel injectors on cylinders that had poor RPM drop, high balance rates, or a noise/smoke change. After repairs, go to step  9.
  8. Replace fuel pressure regulator. After repairs, go to next step.
  9. Operate vehicle under conditions in which concern occurred. Does system operate normally, with no DTCs or symptoms? If yes, system is okay. If no, go to step  2.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.