2002 Chevrolet Venture PlusFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Switches

SWITCHES LOCATION

Component Location
Brake Fluid Level Switch On right side of brake fluid reservoir. See Figure .
Cruise Control Release Switch Mounted on top of brake pedal support.
Driver Seat Belt Switch Inside right half of driver's seat belt.
Engine Oil Level Indicator Switch Mounted on center of oil pan. See Figure .
Engine Oil Pressure Switch On lower left side of engine, above starter. See Figure .
Inflator Air Switch Behind left rear wheelwell. See Figure .
Liftgate Ajar Indicator Switch Part of liftgate lock assembly, below license plate.
Park Brake Switch At left kick panel.
Park/Neutral Position (PNP) Switch Left rear side of engine compartment, mounted to top of transaxle.
Power Sliding Door Detent Switch (2) Mounted to rear opening of respective rear side door.
Power Sliding Door Open/Close Switch Center of respective "B" pillar.
Stoplamp Switch Mounted on top of brake pedal support.
Stoplamp Switch/TCC Switch Mounted to brake pedal support.
Transaxle Range Switch Mounted on top of transaxle.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.