2002 Chevrolet Venture PlusFACTORY OEM SERVICE PROCEDURE

Control Units

CONTROL UNITS LOCATION

Component Location
Auxiliary Module In lower center of dash.
Auxiliary Video Module In overhead console.
Body Control Module (BCM) Below right side of dash.
Cruise Control Module (CCM) On left side of engine compartment, on strut tower. See Figure .
Daytime Running Lamps (DRL) Control Module Behind dash, right of steering column.
Electronic Brake Control Module (EBCM) At lower left side of engine compartment.
Heated Seat Module (2) Beneath respective front seat.
HVAC Control Module Center of dash, below radio.
HVAC Control Module (Auxiliary) Center of headliner.
Ignition Control Module (ICM) On top right side of engine. See Figure .
Inflatable Restraint Side Impact Module (Left) On left side of driver seat back cover.
Inflatable Restraint I/P Module Right top of dash, above glove box.
Inflatable Restraint Sensing & Diagnostic Module (SDM) Below right front seat.
Inflatable Restraint Side Impact Module (Right) On right side of passenger seat back cover.
Inflatable Restraint Steering Wheel Module Center of steering wheel.
Left Rear Side Door Actuator Control Module Behind left rear quarter trim panel.
Memory Seat Module (MSM) Beneath driver's seat.
Powertrain Control Module (PCM) Secured in air cleaner assembly, left front of engine compartment. See Figure .
Rear Object Sensor Control Module Behind trim panel at right front of cargo area.
Rear Side Door Actuator Control Module Behind right rear quarter trim panel.
Remote Control Door Lock Receiver (RCDLR) Behind center of dash, underside of dash trim, near windshield defrost vent.
Theft Deterrent Control Module In steering column, at ignition switch.
Turn Signal/Hazard Flasher Module Below left side of dash, left side base of steering column.
Vehicle Communication Unit (VCU) Below left side of dash.
Vehicle Interface Unit (VIU) Below left side of dash.
Video/Audio/HVAC Module (Rear) Part of overhead console.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.