Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Chevrolet Venture PlusFACTORY OEM SERVICE PROCEDURE
Engine Electrical Diagnostic System Check
- Perform battery inspection test. See BATTERY TESTING & INSPECTION under ON-VEHICLE TESTING. After performing testing, go to next step.
- Connect scan tool to Data Link Connector (DLC). See COMPONENT LOCATIONS . Turn ignition switch to RUN position. If scan tool powers up, go to next step. If scan tool does not power up, see SCAN TOOL DOES NOT POWER UP under SYSTEM TESTS in BODY CONTROL MODULES - MONTANA, SILHOUETTE & VENTURE article in ACCESSORIES & EQUIPMENT.
- Turn ignition switch to RUN position. Using scan tool, attempt to communicate with Instrument Panel Cluster (IPC) and Powertrain Control Module (PCM). If scan tool communicates with each module, go to next step. If scan tool does not communicate with each module, see SCAN TOOL DOES NOT COMMUNICATE WITH CLASS 2 DEVICE under SYSTEM TESTS in BODY CONTROL MODULES - MONTANA, SILHOUETTE & VENTURE article in ACCESSORIES & EQUIPMENT.
- Using scan tool, select DISPLAY DTC function and retrieve any IPC or PCM DTCs. Record all displayed DTCs, status of displayed DTCs and module that set the DTC. If any DTCs are retrieved, go to next step. If no DTCs are retrieved, repair charging system by symptom. See SYMPTOM INDEX table under SYSTEM TESTS.
- If scan tool does not display DTCs which begin with "U", go to next step. If scan tool displays DTCs which begin with "U", see SCAN TOOL DOES NOT COMMUNICATE WITH CLASS 2 DEVICE under SYSTEM TESTS in BODY CONTROL MODULES - MONTANA, SILHOUETTE & VENTURE article in ACCESSORIES & EQUIPMENT.
- If scan tool displays DTCs B1000, B1001, or B1004, repair these DTCs first. See DIAGNOSTIC TROUBLE CODE DEFINITIONS in BODY CONTROL MODULES - MONTANA, SILHOUETTE & VENTURE article in ACCESSORIES & EQUIPMENT. If scan tool displays any other DTCs, perform appropriate test. See DIAGNOSTIC TROUBLE CODE INDEX table.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.