Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Enter Programming Mode
2002 Chevrolet Venture PlusSECTION Enter Programming Mode
Perform the following steps in order to enter the programming mode:
- Turn IP dimmer switch All the way to the right then back slightly to the left.
- With the ignition in the OFF position, remove the BCM PRGRM fuse.
- Turn the ignition to the ACC position.
- Listen to the number of chimes. The chimes indicate the BCM type (2, 3, or 4) and therefore the features that may be personalized.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.