Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Test Description
2002 Chevrolet Venture LT, AWDSECTION Test Description
The numbers below refer to the step numbers in the diagnostic procedures.
- 1
Make sure you perform the I/M System Check before performing this test. Failure to do so may result in difficulty updating the status to YES. - 2
The AIR Tests will begin shortly after the engine goes into Closed Loop Fuel Control. A Passive Test will be performed during Open Loop operation shortly after a cold start up. - 3
This step is to identify a first failure of a type "B" DTC. A DTC only appears on the I/M System Status display when it becomes a MIL illuminating DTC. This occurs on the second failure of a type "B" DTC. A first failure of a type "B" DTC will not allow the I/M System Status to update to YES. See DIAGNOSTIC AIDS . - 4
This step is to help identify any unique or unusual criteria required to run the diagnostic test in the event the universal set procedure does not. See CONDITIONS FOR RUNNING . - 5
The I/M System Status only reports on whether or not a diagnostic has run, not what the outcome of the test was. If any Emission Related DTC sets after the tests are complete, the DTC will require diagnosis.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.