2002 Chevrolet Tracker 2D Utility, RWD, AutomaticFACTORY OEM SERVICE PROCEDURE

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Tracker. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the remote control door lock receiver (2) to the mounting bracket (3). Secure the receiver with 2 screws (1).
    Fig 1: Two Screws & Remote Control Door Lock Receiver
    G01408007Courtesy of GENERAL MOTORS CORP.
  2. Connect the receiver electrical connector (3).
  3. Install the 2 retainers (2, 4) which secure the remote control door lock receiver electrical connector (3).
    Fig 2: Connecting Receiver Electrical Connector
    G01408008Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.