2002 Chevrolet Tracker 2D Utility, RWD, AutomaticFACTORY OEM SERVICE PROCEDURE

Test Description

The numbers below refer to the step numbers on the diagnostic procedures.

  1. 2

    This step checks whether there is communication between the PCM and a scan tool device. If the PCM is unable to provide serial data to the scan tool, there will be no MIL control.
  2. 3

    If other Instrument Panel Cluster (IPC) functions are not working correctly check for an open GAUGE fuse or for a lack of power and ground to the IPC.
  3. 4

    This step checks for an open MIL Control circuit or for an internal PCM failure.
  4. 5

    An open fuse determines if a voltage is constantly being applied to the control circuit.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.