Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Chevrolet Tracker 2D Utility, 4WD, AutomaticFACTORY OEM SERVICE PROCEDURE
Conditions For Running
- Barometric pressure is greater than 75 kPa.
- Engine coolant temperature is 158-230°F (70-110°C).
- Intake air temperature is greater than 18°F (-8°C).
- Battery voltage is 10.5-16.0 volts.
Failure to meet the necessary requirements may produce inaccurate test results.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.