2002 Chevrolet Malibu BaseFACTORY OEM SERVICE PROCEDURE

Control Units

CONTROL UNITS LOCATION

Component Location
Body Control Module (BCM) Below right side of dash, near blower motor. See Figure.
Brake Pressure Modulator Valve (BPMV) At lower left front of engine compartment.
Cruise Control Module (CCM) On right side of engine compartment. See Figure.
Electronic Brake Control Module (EBCM) Inside left front fender.
Ignition Control Module (ICM) On top right side of engine. See Figure.
I/P Dimmer Module On left side of dash.
Powertrain Control Module (PCM) Below left side of dash, near steering column. See Figure.
Remote Control Door Lock Receiver (RCDLR) On rear package shelf.
Sensing & Diagnostic Module (SDM) Under right front seat.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.