Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Chevrolet Impala PoliceFACTORY OEM SERVICE PROCEDURE
BARTEC TPMS Reset Procedure
Using Light Switch
- Inflate tires to correct pressure.
- Turn Ignition ON.
- Turn the light switch from OFF to Parking Lamps 3 times within 5 seconds.
Using Radio
- Inflate tires to correct pressure.
- Turn ignition to ON position (engine off).
- Turn radio off.
- Hold DISP button until SETTINGS is displayed.
- Use SEEK buttons to scroll down until TIRE MON is displayed.
- Press the PREV or NEXT buttons until RESET is displayed.
- Press the DISP button, a chime will sound and DONE is displayed.
- Scroll until EXIT is displayed, press DISP button, chime sounds to signal exit from learn mode.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.