Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Chevrolet Impala PoliceFACTORY OEM SERVICE PROCEDURE
Powertrain Control Module: Installation
- Connect the PCM electrical connectors to the PCM. Tighten connectors to specification. See TORQUE SPECIFICATIONSΒ . Install the PCM and harness into the air cleaner housing. Install the air cleaner housing cover.
- Install the left upper fender brace. Reconnect the negative battery cable. If a new PCM is being installed, program the PCM. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
