Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2002 Chevrolet Impala LSFACTORY OEM SERVICE PROCEDURE

Remote Control Door Lock Receiver: Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 Chevrolet Chevy Express, and 2001 GMC Savana Special. However, it is still accessible from the selected car via links, so may be relevant.

Install remote control door lock receiver (2) to vehicle. Install plastic fasteners that retain remote control door lock receiver (2) to sound insulation. Connect electrical connector to remote control door lock receiver (2). Initiate transmitter programming or reprogramming. See TRANSMITTER PROGRAMMING . Install engine cover. Connect negative battery cable. Refer to Fig 1 .

Fig 1: Remote Control Door Lock Receiver Removal & Installation

Courtesy of GENERAL MOTORS CORP.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.