2002 Chevrolet Impala LSFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Switches

SWITCHES LOCATION

Component Location
A/C Pressure Switch On A/C line, lower left front of engine compartment. See Figure.
Automatic Transaxle Fluid Pressure Manual Valve Position Switch In automatic transaxle.
Brake Fluid Level Switch In master cylinder reservoir.
Coolant Level Switch Right upper rear of radiator.
Cruise Control Release Switch Behind left side of dash, on brake pedal support.
Engine Oil Level Switch (3.4L VIN E) Front center of oil pan.
Engine Oil Level Switch (3.8L VIN K) Left center of oil pan.
Engine Oil Pressure (EOP) Switch (3.4L VIN E) On left side of engine, above starter. See Figure.
Engine Oil Pressure (EOP) Switch (3.8L VIN K) Front right of engine, below power steering pump.
Park Brake Switch At base of parking brake assembly.
Park/Neutral Position Switch In automatic transaxle.
Stoplamp Switch On brake pedal support.
Sun Roof Opening Position Switch Above sun roof motor.
Windshield Washer Fluid Level Switch In washer fluid reservoir.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.