Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Chevrolet Impala LSFACTORY OEM SERVICE PROCEDURE
Installation Procedure
- Install the traction control switch (1) to the IP cluster trim plate (2).
- Connect the electrical connector (1) to the traction control switch (2).
- Align and carefully press the IP cluster trim plate into the IP trim pad. Make sure all of the retainers are fully engaged.
- Install the LH IP cluster trim plate screws. Tighten the IP cluster trim plate screws to 2 N.m (18 lb in).
- Install the LH instrument panel (IP) fuse block access opening covers.
- Install the ignition switch cylinder bezel.
- Return the steering wheel to the original position.
- If equipped with a column shift, position the transaxle shift control indicator to Park.
- If equipped with column shift, release the parking brake.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.