Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Chevrolet Cutaway 6.5 FFACTORY OEM SERVICE PROCEDURE
PCM Programming
- Verify the following for the setup:
- The battery is charged.
- The ignition is ON.
- The battery/cigarette lighter connection is secure.
- The Data Link Connector (DLC) is attached.
- Perform the programming. See the up to date Techline terminal/equipment for user instructions.
- Perform the Passlock(tm) Learn Procedure. See THEFT DETERRENT PASSWORD LEARN PROCEDURE .
- After the vehicle has been programed, operate the vehicle until the coolant temperature is more than 170°F (77°C). This will allow the Top Dead Center (TDC) offset to be programed. See FUEL INJECTION PUMP TOP DEAD CENTER OFFSET ADJUSTMENT .
- Check the Data list for a TDC offset.
- If the PCM fails to reprogram, do the following:
- Check all the Powertrain Control Module (PCM) connections.
- Check the Techline terminal/equipment for the latest software version.
- Try again to reprogram the PCM. If the PCM fails again, replace the PCM. See appropriate REMOVAL, OVERHAUL & INSTALLATION article.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
