Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Chevrolet Corvette Base, 2D Convertible, AutomaticFACTORY OEM SERVICE PROCEDURE
Steering Column DTCS
STEERING COLUMN DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description |
|---|---|
| DTC B2587 | Open/Short To Ground In Column Lock Drive A Circuit, Or BCM Battery Voltage Circuit From BCM2 Fuse |
| DTC B2588 | Open/Short To Voltage In Steering Column Lock Circuit |
| DTC B2592 | Open/Short To Ground In Steering Column Unlock Circuit, Or Open BCM Battery Positive Voltage Circuit From BCM2 Fuse |
| DTC B2593 | Internal Malfunction, Open Or Short To Voltage In Steering Column Unlock Circuit |
| DTC B2852 | Steering Column Switch Input To SCM, Is Active For More Than 20 Seconds |
| DTC B2857 | Steering Column Switch Input To SCM Is Active For More Than 20 Seconds |
| DTC B2860 | Steering Column Position Sensor Signal To SCM Is Less Than 0.1 Volt Or Greater Than 4.78 Volts For 2 Seconds Or More |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
